PSTN SIP trunk inbound calls

[csco11030279]

Hi;

i have this issue with the cisco voice gateway , our setup CUCM-H323-VGWAY-SIP-SP,

when I dial from any number to the out main number , it is rining , but when I pick up the call , it takes some time to show in the phone screen that call is connected , and after some time also the call disconnected .

anybody has any idea?

[Carlo Poggiarelli]

Hi.
Please attach a debug voice ccapi inout and debug ccsip message during a call

Thanks

Carlo

Sent from Cisco Technical Support iPhone App

[William Morales]

Hi,

That call is not matching any outgoing dial peer: "CALL_ERROR_INFORMATIONAL; Call Entry Is Not Found"

Your call flow description mentioned that you are using SIP from your gateway to your provider but the only dial peer on your configuration matching the dialed digits is this one:

dial-peer voice 5001 pots

destination-pattern 0559669904

no digit-strip

port 0/0/0

Regards.

[csco11030279]

Here is the debugs

Thanks for the replay

[csco11030279]

The gateway also has FXO this dial peer for outgoing through the FXO.

my issye with the SIP trunk from the SP,

[Nishant Savalia]

Hi,

Can you please share "debug h245 asn1" for the same.

Also please share your H.323 gateway snapshot in CUCM.

Regards,

Nishant Savalia

[Carlo Poggiarelli]

Hi

Try to add following DP.

dial-peer voice 5412 voip

incoming called-number 22846..

session protocol sipv2

dtmf-relay rtp-nte

codec g711alaw

no vad

HTH

Regards

Carlo

Please rate all helpful posts

"The more you help the more you learn"