Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Public Access IP Phones

Greetings -

We are running CUCM v6.1 in a single-site topology. We have several "hot spots" where we need to place a wired public access phone (7911G).

My plan was to create a separate partition along with separate CSSs for these particular phones. Also, I was planning on creating separate route patterns so that I could implement FAC for these particular phones.

Just wondering if I am going about this the correct way. Would there be something better in the way of implementing.

Any feedback would be appreciated. Thx.

Joe

2 REPLIES
New Member

Re: Public Access IP Phones

You are on the right way.

different separate Partition with separate CCS, and new route patterns with FAC codes.

New Member

Re: Public Access IP Phones

Thx for the clarification

I just wanted to make sure that I was going about it the right and that there was not a better or more efficient way of implementing.

Thx again.

Joe

221
Views
0
Helpful
2
Replies