Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Publisher down no PSTN calls

Hi all,

need help on if my publisher     is down     and when i try to call PSTN with sip trunk to service provider i get busy tone.but phones are getting registered with subscriber without issue and can also recieve call from PSTN.

cucm 8.5

advices are appreciated.

Everyone's tags (3)
1 ACCEPTED SOLUTION

Accepted Solutions

Publisher down no PSTN calls

Hi

After the Pub is down ,

1-can you check please check the status of your Trunk?. Please also when your Pub is down , try to do reset to your trunk and try again the outgoing calls.

2-Did you configure route list , if yes what about other gateways on your RL have the same porblem?.

Thank you

please rate all useful information

9 REPLIES

Publisher down no PSTN calls

Hi

Do you have a dial peer into VG pointed to the SUB?

The call reach the VG when the PUB is down?

Please rate all useful posts

Regards
Chrysostomos

""The Most Successful People Are Those Who Are Good At Plan B""

Please rate all useful posts Regards Chrysostomos ""The Most Successful People Are Those Who Are Good At Plan B""
New Member

Re: Publisher down no PSTN calls

Please provide additional info about your network - how calls are going between CUCM and your SIP provider; if there is a CUBE in use; if there is a NAT translation between networks; any other information that may help.

When the publisher is working your phones are registered on it and calls are going to your SIP provider successfully, am I correct?

Kind regards,
Andrew C.

Kind regards, Andrew C.
New Member

Publisher down no PSTN calls

yes , cucm sub --> cube---> ISP call are going fine.

device pool SUb-pub

when pub is not reachable then sub has phones registered but no outgoing call sub-->cube.---> ISP not working

but incoming calls are working

New Member

Re: Publisher down no PSTN calls

Please attach the output of "debug ccsip messages" for a call from sub to sip provider and configuration of dial peers.

Kind regards,
Andrew C.

Kind regards, Andrew C.
Cisco Employee

Publisher down no PSTN calls

Most likely your outbound calls config in CUCM doesn't have configure a CUCM group which has both servers for this to happen. If that's the case, right now there's nothing to do if your PUB is down, as you cannot change anything without it.

HTH

java

if this helps, please rate

www.cisco.com/go/pdihelpdesk

HTH

java

if this helps, please rate

www.cisco.com/go/pdi
New Member

Re: Publisher down no PSTN calls

is there anything with the database , there was some restarts going on for subscriber due to hardware issue.

if i do dbreplication reset will it solve.

Publisher down no PSTN calls

that debug that you attached "calls not going out.txt.xip" contains a debug of an inbound call:

Oct 10 13:55:18.433: //-1/xxxxxxxxxxxx/SIP/Msg/ccsipDisplayMsg:

Received:

INVITE sip:2613977@172.29.8.238;user=phone SIP/2.0

Via: SIP/2.0/UDP 10.200.7.157:5060;branch=z9hG4bKhcp22t2pa4ddoa2oftf7hs4fbT14355

Record-Route: <10.200.7.157:5060>

Call-ID:

isbcusbkf4aecoapackhueu4tcdaopcefpeh@SoftX3000

From: <566882791>;tag=sbc0806ukktdctk-CC-22

To: <2613977>

CSeq: 1 INVITE

Contact: <566882791>

Allow: INVITE,ACK,OPTIONS,BYE,CANCEL,REGISTER,INFO,PRACK,SUBSCRIBE,NOTIFY,UPDATE,MESSAGE,REFER

User-Agent: Huawei SoftX3000 V300R010

Supported: 100rel

Max-Forwards: 70

Content-Length: 369

Content-Type: application/sdp

can you send a debug when making an outbound call .

Thanks


=============================
Please remember to rate useful posts, by clicking on the stars below.

=============================

Please remember to rate useful posts, by clicking on the stars below.

Publisher down no PSTN calls

Hi

After the Pub is down ,

1-can you check please check the status of your Trunk?. Please also when your Pub is down , try to do reset to your trunk and try again the outgoing calls.

2-Did you configure route list , if yes what about other gateways on your RL have the same porblem?.

Thank you

please rate all useful information

New Member

Re: Publisher down no PSTN calls

Hi is_mail123,

There are a couple of things that needs to be checked.

But we need to understand why is the Service Provider not accepting the call.

Best way to find out is to check with the service provider.. why they are not accepting the call.

Else just compare debugs ccsip messages from the GW with working an non-worning ones.

In case you find that the INVITE message is sent to the GW from CUCM then CUCM seems good.

In case GW does not send the INVITE message then we have to troubleshoot the GW rather than CUCM.

Hence for now we have to focus where are we going wrong from the debugs

For dbreplication issues use these commands:

utils dbreplication status

utils dbreplication runtimestate

HTH

Regards,

Tirtha

656
Views
0
Helpful
9
Replies
CreatePlease to create content