Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Putting 9971 in Power Save mode in CME

Hi All,

Can't figure this one out for a while.  How do you put a SIP endpoint namely the 9971 into power save mode in a CME system (ie turn off the screen when not in use).

For a SCCP endpoint there are commands under "telephony-service" to do so, but these won't apply to a SIP endpoint.  There doesn't seemed to be equivalent commands under the SIP "voice register global".  Anyone has any ideas?

Thanks in advance for any tips and assistance.

Everyone's tags (4)
1 ACCEPTED SOLUTION

Accepted Solutions

Putting 9971 in Power Save mode in CME

Hello ,

I think I answered a similar post before . Can you check this...

https://supportforums.cisco.com/message/4012873#4012873

Hope this helps!

Regards,

Karthik Sivaram

2 REPLIES

Putting 9971 in Power Save mode in CME

Hello ,

I think I answered a similar post before . Can you check this...

https://supportforums.cisco.com/message/4012873#4012873

Hope this helps!

Regards,

Karthik Sivaram

New Member

Putting 9971 in Power Save mode in CME

Yes that thread answered my question perfectly.  Thanks.

605
Views
0
Helpful
2
Replies