Yes. I mentioned in the initial post that show diag seems to work fine. When I use call manager to set up a call out feature on an FXO port, the description doesn't look right. That is why I was looking at why the DSP doesn't show up in show ver. Any ideas? Is this normal?
Yes. And I went ahead and added the new gateway in call manager and it worked fine. Maybe DSPs don't show in the ver on this model. I have been working on 2801s for the rest of my project, this just threw me for a loop. Thanks for your input.
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: firstname.lastname@example.org Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...