Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

PVDM Location

I tried to configure E1s on 3845 when I tried to add the configuration under e1 I got a message that:

% Not Enough DSP services

I checked show diag I found the PVDM on slot 0 and e1 on slot 1.

I turned off the router and I moved the PVDM from slot 0 to 1 and every thing works fine.

I need to know if there is a way to use the PVDM on slot 0 to configure E1 on slot 1

1 ACCEPTED SOLUTION

Accepted Solutions

Re: PVDM Location

Hi,

DSP Sharing. If you like to read about it:

http://www.cisco.com/en/US/docs/ios/12_3/vvf_c/interop/intcnf2.html#wp1010335

Best regards,

-- Adrián.

2 REPLIES
Hall of Fame Super Silver

Re: PVDM Location

Yes, add the following command:

voice-card 0

  dspfarm

HTH,

Chris

Re: PVDM Location

Hi,

DSP Sharing. If you like to read about it:

http://www.cisco.com/en/US/docs/ios/12_3/vvf_c/interop/intcnf2.html#wp1010335

Best regards,

-- Adrián.

191
Views
5
Helpful
2
Replies
CreatePlease to create content