Hello I have c3745 router It has 2mft-e1, 2mft-t1 and two pvdm-32 on nm module 2mft-t1 on nm module, e1 on onboard wic I try to create controller 2 t1 is alright (each 5 channel) but 2 e1 cannot create because not enough dsp. Can I solve this problem? Thanks Sent from Cisco Technical Support Android App
If you do not want to buy new dsp , check if you have unnecessery media resources configured. Such as confrence bridge or xcoders. You can try removing 1 conf session and it will allow you some channels to configure.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.