Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

PVDM

Hi,

Unable to see voice-port command in 3845 router.

PVDM2-64 modules have been installed and displayed in "sh diag"

NM-1CE1T1-PRI has been configured and the "isdn status" is also up.

Any suggestions..

2 REPLIES

Re: PVDM

HI friend,

Did you saw this link?, may be helpful.

Notice the card type command.

http://www.cisco.com/en/US/docs/ios/12_3/feature/guide/gt_et2sw.html

Regards,

- adrián.

Hall of Fame Super Gold

Re: PVDM

Hi, you cannot use NM-1CE1T1-PRI for voice, that is a data only card.

You need a VWIC or VWIC2 card for voice PRI on an ISR router.

Hope this helps, please rate post if it does!

136
Views
5
Helpful
2
Replies
CreatePlease to create content