I have a typical network Main site with two remote sites. At each site there is a 2800 and a downstream 3550 poe switch where the phones connect. I need to set up some local LAN qos on the ports and then prioritise the voice traffic across the WAN. I am quite new to QOS so could any body give me a guide of where to start or provide any sample configs?
one site has a 2811 router with a connected les 10 circuit which connects back to the main site remote site two has a 2600 with a 2mb leased line Both remote site ciruits are provided by BT. The mail site has 4500 which terminates both remote site connections
For the 10 mpbs circuit, once again I would not configure anything. For the 2 mpbs, give a look to "show interfaces" on both sides. If you have "packet drops" increasing a peak times, you may want to configure basic LLQ per document:
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: firstname.lastname@example.org Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...