I am using Cisco CM5.1.3 in my office. Now i want some good document which refer's to specific QoS commands that should be used in Access & Core layer of data infrastructure and which are considered as Industry best practices.
Any help in this regard will be really appreciated.
QoS is a extensively broad topic, and in most cases is platform specific. Please take a look at the Network Infrasture section within the SRND, this discusses the various QoS methods and deployments and would be a good place to start.
If you are looking for specific QoS commands, you should look at QoS for your given platforms. For example there are number of documents on CCO for the 6500 which discuss marking, policing and egress scheduling techniques for both Native and Hybrid.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...