1. I am working for a few different school districts as a phone-in-tech. They all have VoIP issues where calls will be dropped during when there is alot of network traffic. None of the switches have any QoS implemented on them. I am wondering what commands are needed to properly configure QoS through out the network.
But most importantly I am trying to understand what the commands mean.
I feel like I have a good grasp of the mls qos map cos-dscp command means. Im not too positive on what the numbers after it mean. I think I understand it as a ranking of some sort.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...