can someone explain to me how/where/if the incoming calls to a gateway have dscp/precedence applied.
I see within Clusterwide Parameters under services, on CCM that there are settings there, but are these automatically applied to calls coming in via a gateway, or is this something I need to do on each individual gateway.
Dave / Sankar, thanks both for the replies; answers my question. I do have a follow on however, do you bother applying any qos control methods to the fastethernet interface of the router, or because 99% of the traffic will be either signalling or media, don't bother. Also is there any counters in place to indicate the quantity of packets marked.
Typically you dont need to, unless you want to remark the packet tags to something else (say cs3 to af31) as most MPLS or other types of wan circuit providers use different tags for qos in their cloud. If using a packet remarking policy map on the fastE, you will be able to see the counters using show policy-map interface fa0/0 command.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.