Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

QoS Question

Hi Guys,

I know this is the telephony forum but it's a QoS question based on priority queuing.

Bascially, below is the output of "sh policy-map int <inteface>.  There's only one match criteria under CM-3COM-PHONES-EF being matched and it's being given priority bandwidth.  My question is how can the class map show 44120 amount of packets matched but under queuing, 0 amount are showing as matched.

Appreciate if you could clear it up for me.

Thanks,

Neil

Service-policy output: PM-QOS-PRIORITY

    Class-map: CM-3COM-PHONES-EF (match-all)
      44120 packets, 4158010 bytes
      5 minute offered rate 0 bps, drop rate 0 bps
      Match:  dscp ef (46)
      Queueing
        Strict Priority
        Output Queue: Conversation 40
        Bandwidth 100 (kbps) Burst 2500 (Bytes)
        (pkts matched/bytes matched) 0/0
        (total drops/bytes drops) 0/0

    Class-map: class-default (match-any)
      126422 packets, 10851836 bytes
      5 minute offered rate 3000 bps, drop rate 0 bps
      Match: any
      Queueing
        Flow Based Fair Queueing
        Maximum Number of Hashed Queues 32
        (total queued/total drops/no-buffer drops) 0/0/0

1 REPLY
New Member
118
Views
5
Helpful
1
Replies
CreatePlease to create content