We have a customer that's using a 2950XL switches with IOS 12.01 and 3500XL series switches. I know you can do limited QOS configuration on them. What type of QOS can be configured on the 295XL and 3500 Xl switches.
I basically need some facts that I can give the customer so he would believe that a upgrade will be in the company's best interest.
Catalyst 2900 XL and 3500 XL series switches do not provide any priority scheduling in the input side. However, they do provide priority scheduling in the output/egress port.
Catalyst 2900 XL and 3500 XL series switches honor the incoming Class of Service (CoS) value in the dot1q tag. All the ports are considered trusted ports by default. Since dot1q does not tag the native VLAN traffic, issue the switchport priority default <0-7> interface level configuration command to classify the incoming untagged packet as desired. The switchport priority default <0-7> command is issued to provide CoS equivalent egress scheduling. If the egress port is a trunk port, the ingress CoS or port default priority configuration is marked in the outgoing frames as CoS values for the far-end device to treat them with the desired higher priority.
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: firstname.lastname@example.org Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...