QRT Softkey doesnt work. Nothing happens when pressed. CM 7.1
1. After the upgrade from 4.x to 7.1 nothing happens when pressing the QRT Softkey. The users have the correct template and the Cisco Extended Functions is activated as well. I went through the user guides "manager features and services" and "unified communications manager system" , but it still doesnt work.
2.When we were using version 4.x of CM we had an email sent out when someone pressed the QRT Softkey. The QTR button is set up to "interview" when someone presses it. No email is being sent out. This could be related to the other problem described above, but I have been unable to find anywhere in the documentation where you set up email notification.
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: email@example.com Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...