Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

qsic trunk

  i am trying to  configuredqsic trunk between cme and panasonic pbx.but the controller is down.here is the show command.

cme#show controllers e1

E1 0/2/0 is down.

  Applique type is Channelized E1 - balanced

  Transmitter is sending remote alarm.

  Receiver has loss of signal.

  alarm-trigger is not set

  Version info Firmware: 20100222, FPGA: 13, spm_count = 0

  Framing is CRC4, Line Code is HDB3, Clock Source is Internal.

  Data in current interval (649 seconds elapsed):

     0 Line Code Violations, 0 Path Code Violations

     0 Slip Secs, 0 Fr Loss Secs, 0 Line Err Secs, 0 Degraded Mins

     0 Errored Secs, 0 Bursty Err Secs, 0 Severely Err Secs, 649 Unavail Secs

  Total Data (last 24 hours)

     0 Line Code Violations, 0 Path Code Violations,

     0 Slip Secs, 0 Fr Loss Secs, 0 Line Err Secs, 0 Degraded Mins,

     0 Errored Secs, 0 Bursty Err Secs, 0 Severely Err Secs, 86400 Unavail Secs

what could be the reason?

thanks

kavi

4 REPLIES
Hall of Fame Super Gold

qsic trunk

Duplicate post #1.

Hall of Fame Super Silver

Re: qsic trunk

Try different cable and crossover.

Sent from Cisco Technical Support iPhone App

New Member

Re: qsic trunk

Hello,

make CME trunk as master and panasonic as salve , waht you are using here , can you paste show isdn st here . here it alos shows loss of signal , check yr cabling aprt too

rgds

Amim

      

if this helps, please rate

New Member

Re: qsic trunk

hi,

and make sure you use all 30 channel of E1 ,as sometime it does not worked with fragmneted channel .

rgds

AMim

      

if this helps, please rate

274
Views
0
Helpful
4
Replies
CreatePlease login to create content