Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

QSig path replacement from a IOS Gateway ?

is it possible for a Voice Enabled IOS Gateway (eg. 2811) to send a qsig path replacement using either tcl scripts or something similar ?

I dont have a CM to backhaul signaling info to.

The senario is

PBX------> GW (TCL scripts app)

<---- Call Transfer back to PBX

Currently the calls gets hairpinned.

Thanks

2 REPLIES
Hall of Fame Super Gold

Re: QSig path replacement from a IOS Gateway ?

Hi,

no I don't think is possible to control qsig features via TCL - I may be wrong but from writing some script it does not seem to me it can be done.

New Member

Re: QSig path replacement from a IOS Gateway ?

Yes, the Tcl guide talks only of a few kinds of transfers that are supported and qsig is not one of them .

However, I wonder if its possible (in theory at least) to perhaps backhaul QSIG signalling

from the gateway to a non cisco MGCP stack , and have that process send the QSIG facility message to do a path replacement.

491
Views
0
Helpful
2
Replies