Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Quality Management - recording quality issue

I have a QM v2.6.1 installation integrated with CUCM 7.0 & CUCX 7.0. The QM application is configured for server based recording only, so nothing is installed in the client PC.

I have completed the configuration and the recordings are saved in the SQM\audio directory. The problem is that when I listen to these recordings, either with the QM desktop or with any media player after saving the file, the quality of the recording is very bad. Most of the times you can not even hear anything, only noise. This happens for both internal and external calls. The codec used for all calls is G711ulaw.

Any idea why this happens?

Thanks in advance.

5 REPLIES
Cisco Employee

Re: Quality Management - recording quality issue

You should probably contact TAC and ask to open a support case with Calabrio as they are the OEM for QM and troubleshoot QM issues.

http://www.calabrio.com/support.asp

Regards,

Teresa.

Regards, Tere. If you find this post helpful, please rate! :)
New Member

Re: Quality Management - recording quality issue

HI

am facing the same issue as yours.

any luck on your end.

Thanks in advance

New Member

Re: Quality Management - recording quality issue

Hello,

In my case the issue was improper configuration of the monitoring session in the switched. I had configured the switch to monitor received and transmitted packets on each port including the trunk ports. This caused duplication of recorded packets resulting in bad voice quality. You have to configure the session to monitor only received packets on the access port and not monitor trunk ports.

Hope this helps.

New Member

Re: Quality Management - recording quality issue

thanks,

i have configured on the switch as

monitor session 1 source int gi 2/1

monitor session 1 destination r-span 5

the phone ports on the switch are monitored for both directions. should i only monitor the rx direction only.

New Member

Re: Quality Management - recording quality issue

I think you should try to monitor only rx.

288
Views
0
Helpful
5
Replies
CreatePlease login to create content