Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Community Member

Quality of service for Voice Gateway

Hi

We are implementing QoS for IP Telephony infrastructure. The IP Phones mark the packets for signalling and RTP. This would be for the traffic originating at the phone towards the voice gateway.

What and how should the marking happen for a call from PSTN towards the Ip phone? Is there separate marking to be done on the voice gateway or the switches.

Thanks.

2 REPLIES
Hall of Fame Super Gold

Re: Quality of service for Voice Gateway

Router sets the right value by default. With H.323 or SIP, you cahnge it under dial/peer. With MGCP, configure the CM for this.

VIP Red

Re: Quality of service for Voice Gateway

what ever is doing the marking for RTP traffic coming from the Voice gateway:

add the following line to the access list that defines the required DSCP or presedence value:

permit udp any any range 16384 32767

Please remember to rate useful posts, by clicking on the stars below.

214
Views
6
Helpful
2
Replies
CreatePlease to create content