02-27-2009 04:43 AM - edited 03-15-2019 04:30 PM
I have a question about tech-prefix in GW as followed,
Requirement:
1)Local zone GK, domain: cisco.com
That's only command in gatekeeper.
2)Tech prefix: 1 for ccm, 852 for CME.
I don't known how to defind tech-prefix in VG, i'm not sure whether the beloing configure is fine.
-----GK----
int lo 1
ip add 2.2.2.2 255.255.255.0
gatekeeper
zone local GK cisco.com
no sh
-----GW (CME)----
int lo0
ip add 1.1.1.1 255.255.255.0
h323-gateway voip bind srcaddr 1.1.1.1
h323-gateway voip h323-id CME
h323-gateway voip id GK ipaddr 2.2.2.2
h323-gateway voip interface
h323-gateway voip tech-prefix 852 ????????not sure????????
dial-peer voice 1 voip
destination-pattern 900.T
sesstion targe ras
tech-prefix 1 ????????not sure????????
03-05-2009 07:04 AM
To configure a technology prefix in the gatekeeper, use the gw-type-prefix command.
To define the technology prefix that the gateway will register with the gatekeeper, use the h323-gateway voip tech-prefix interface configuration command.
h323-gateway voip tech-prefix prefix
To specify a particular technology prefix be prepended to the destination pattern of a specific dial peer, use the tech-prefix dial peer configuration command.
tech-prefix number
03-06-2009 07:04 AM
hi
i had some prevous post in regard to this might help you
if helpful Rate
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide