Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Question about CME SRST

I'm preparing to configure CME SRST on a 2811 CM 4.2 MGCP gateway with 4 FXO lines. The documentation on configuring SRST is very simple, especially if you are not looking to preconfigure ephones onto the system.

My question is; in the documentation and in the example configurations I have read I have not seen examples of dial-peers that have to be added to support CME SRST. When you configure SRST on a CM 4.2 mgcp gateway you add a pots dial-peer to handle and outbound calls. In the examples I have seen, there have only been the mgcp dial peers that CM installs during configuration. Can someone help me understand why this is?

-Shikamaru

1 REPLY
Bronze

Re: Question about CME SRST

Cisco Survivable Remote Site Telephony (SRST) offers a smaller set of call handling capabilities than Cisco CallManager. Much of the configuration for the SRST feature involves enabling existing Cisco CallManager or IP phone settings.

This URL should help you:

http://www.cisco.com/en/US/products/sw/voicesw/ps2169/products_configuration_guide_chapter09186a008065cb07.html

98
Views
0
Helpful
1
Replies