Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

question about the output of debug isdn q931

                   HI there,  I have a quick question. when use debug on the voice gateway with above command,  it will display the called number. My understanding is that this called number is sent from CUCM and this number will match one of the dial peer in router and then go throught the voice translation profile, then be sent out to ISDN, am I correct?   if so, which command can show me the exact number after digits manipulation on router sent to the Telco?

Everyone's tags (5)
1 ACCEPTED SOLUTION

Accepted Solutions
VIP Super Bronze

question about the output of debug isdn q931

Hi,

Debug voip ccapi inout..if you are using h323 gateway and

debug ccsip messages, if you sre using a sip trunk/gateway

Please rate useful posts

"For the love of God is broader than the measure of man's mind And the heart of the Eternal is most wonderfully kind"

Please rate all useful posts "The essence of christianity is not the enthronement but the obliteration of self --William Barclay"
3 REPLIES
VIP Super Bronze

question about the output of debug isdn q931

Hi,

Debug voip ccapi inout..if you are using h323 gateway and

debug ccsip messages, if you sre using a sip trunk/gateway

Please rate useful posts

"For the love of God is broader than the measure of man's mind And the heart of the Eternal is most wonderfully kind"

Please rate all useful posts "The essence of christianity is not the enthronement but the obliteration of self --William Barclay"
Hall of Fame Super Silver

question about the output of debug isdn q931

IN addition you can also use:

debug voice dialpeer

and

debug voice translation

to see exactly which dial peer is matching after which digit and what is being translated to what.

Chris

Super Bronze

question about the output of debug isdn q931

 if so, which command can show me the exact number after digits manipulation on router sent to the Telco?

For an outbound call (from CUCM to ISDN) that would be debug isdn q931 as you are using already. That shows the actual setup message sent out on the ISDN after any manipulation.

Obviously for inbound calls, it shows what you receive from the PSTN before any manipulation happens.

Aaron

Aaron Please remember to rate helpful posts to identify useful responses, and mark 'Answered' if appropriate!
716
Views
0
Helpful
3
Replies