I have UCM 6.1.2. We have two receptionist that want to be able to share the incoming call load. And at night the calls go to voice mail when they log out. I setup for the call distribution to be top down and go to phone A line 1, phone B line 1, Phone A line2 and so on, with the last object being a port that forwards to the night greeting. The problem is that phone A gets all the calls first, only if she is on the phone does it go to phone B, which is how it is designed. However they are not too keen on that design. If I change the distribution to Most Idle, the voice mail port will pick up every now and then. I tried to set the Call Forwarding up on the hunt pilot but that did not seem to work. So either I am doing something wrong or is there a better way to set this up.
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: email@example.com Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...