I hav a Cisco 3700 with two NM-HDV (one E1 port in each NM-HDV). The NM-HDV is connected (back-to-back) to two Cisco 2800.
If each E1 port is configured to obtain clocking from the line and "show network-clocks" shows that the C3700 router is using the backplane as the clock reference. Will there be any potential clocking issue?
Do i need to configure "network-clock-participate" ? The default is "no network-clock-participate"
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.