Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

"ERROR: could not add peer " in CME

Hi,

Iam not able to add ephone-dn when i add error displayed as"ERROR: could not add peer"

What causes this is it Memory can anyone explain in detail ?

Thanks,

Hari

3 REPLIES
Hall of Fame Super Gold

Re: "ERROR: could not add peer " in CME

This is a bug (memory leak) I've meet many times, but never got an ID for.

Only workaround is to reload the router. I haven't seen it happening in recent versions.

New Member

Re: "ERROR: could not add peer " in CME

Hello Hari,

i had the "same" problem. We updateded a CUCM form 6.1.2 to 7.1.2. So we also updated the SRST Gateways to 12.4(24)T1.

After this our 3825 Gateways with 256 MB Mem refused the command max-dn. It still worked, but only for very low numbers. (up to 23). So I opend a TAC Case and the anser was

#########################################

The system is now

telling you that there is not enough memory to add dial-peers into the

system. Note that the threshold is 80% for 256M or less, 85% for

256-512M and 90% for > 512M of processor memory. The system will not let

you add ephone-dn's (dial-peers) when it's available processor memory is

below that threshold.

Below is two relevant URL that discuss this:

How to determine the maximum number of dial-peers that can be configured

on a router

http://www.ciscotaccc.com/kaidara-advisor/voice/showcase?case=K34857008

When calculating the memory requirements for the number of dial-peers

required you can use the following:

Router>show memory summary

Head Total (b) Used (b) Free (b) Lowest (b)

Largest (b)

Processor 60AB4ED0 5550384 2082996 3467388 3464996

3454608

I/O 40000000 16777216 1937280 14839936 14839936

14838908

Total = the total amount of memory available after the system image

loads and builds its data structures.

#########################################

We also saw in the following document that 512 MB of memory are recommended.

http://www.cisco.com/en/US/docs/voice_ip_comm/cusrst/requirements/guide/srs71spc.html

Bye

Jo

New Member

Re: "ERROR: could not add peer " in CME

As a Temp solution i will reboot the router.

Thanks

hari

1413
Views
7
Helpful
3
Replies
CreatePlease login to create content