Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

"ignoredisplayieinconnect" endpoint used on CallManager EURO PRI gateway

Can anybody shed any light on the "ignoredisplayieinconnect" endpoint that we seem to have setup on our Callmanager here in the office? (v3.3)

Allegedly these endpoints are needed because the check-boxes for "Redirecting Number IE Delivery - Inbound/Outbound" dont always work - thus the endpoint description needs to be explicit.

we seem to have one of these endpoints on EACH CMM module where we have endpoints that handle in/outbound calls.

Was this just a quirk of v3.3....?

1 REPLY
Bronze

Re: "ignoredisplayieinconnect" endpoint used on CallManager EURO

If specified, CCM will only ignore the Display IE in the received CONNECT message. It will not affect the Display IE

received in other I messages.

123
Views
0
Helpful
1
Replies
CreatePlease to create content