Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

"Not enough bandwith" problems

Hello,

i have some problems with  "Not enough bandwith" error message on some device pools.

Allthough there is enough bandwith allocated in System -> Locations.

Is there any possibility where i can monitor the cac consumption of certain device pools.

Any hints?

Regards

Walter

1 ACCEPTED SOLUTION

Accepted Solutions
Green

"Not enough bandwith" problems

Hi,

Use RTMT

System --> Performance ---> Pick the Server you want to monitor
---> Cisco LOcations ---> Choose Locations you want to monitor
---> Bandwidth Available

The graph should change as the usage rises & falls

Hth
Alex

Regards, Alex. Please rate useful posts.
5 REPLIES
Green

"Not enough bandwith" problems

Hi,

Use RTMT

System --> Performance ---> Pick the Server you want to monitor
---> Cisco LOcations ---> Choose Locations you want to monitor
---> Bandwidth Available

The graph should change as the usage rises & falls

Hth
Alex

Regards, Alex. Please rate useful posts.
New Member

"Not enough bandwith" problems

Hello Alex,

Great. Just for this i was looking for.

Many thanks.

Walter

New Member

"Not enough bandwith" problems

are you using UCM version 7.1.x?

New Member

"Not enough bandwith" problems

7.1.5

New Member

"Not enough bandwith" problems

walter, this is a known bug with this version as of 7.1.3. Contact Cisco, they will tell you about.  We had this problem as well.

397
Views
0
Helpful
5
Replies
CreatePlease to create content