Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Users might experience few discrepancies in Search results. We are working on this on our side. We apologize for the inconvenience it may have caused.
New Member

"special" call transfer

Hello friends,

Is it possible to configure, in CME, an extension to transfer the call NOAN after X seconds, but after the transfer, it rings on the destination extension and still rings in the original destination extension? (two phones ringing)?

Thank you,

Met.

1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Gold

Re: "special" call transfer

Be aware, parallel ephone hunt works on in CME 4.3, as of today at the very first release.

For previous versions, you will have to CFNA to another DN that is shared/overlay.

Hope this helps, please rate post if it does!

4 REPLIES
Blue

Re: "special" call transfer

In CME you can setup a 'simultaneous ring' line (using a hunt list/group/pilot)

Make the pilot, the number you want to ring after the NOAN and use the 'broadcast' distribution algorithm on the hunt list.

(or a shared line of the number that rings after the NOAN would work)

Hall of Fame Super Gold

Re: "special" call transfer

Be aware, parallel ephone hunt works on in CME 4.3, as of today at the very first release.

For previous versions, you will have to CFNA to another DN that is shared/overlay.

Hope this helps, please rate post if it does!

New Member

Re: "special" call transfer

Thanks Paolo. Had to deal with shared lines (that raised another problem with login logout in hunt groups for bacd...but ill live with that i guess!).

Thanks again!

Met

Blue

Re: "special" call transfer

oops....mistated the first edit...that was for CCM...sry :(

140
Views
0
Helpful
4
Replies
CreatePlease to create content