10-11-2008 08:28 AM - edited 03-15-2019 01:52 PM
Hi,
I'm facing the following problem. I have router in SRST mode and I want to reach the Cisco Unity through PSTN (R2 Digital without ANI). I have tried the vm-integration but it doesn't work. Also tried to prefix in dial-peer with pauses ",,,," but still no success.
Is there a way to transfer the DTMF digits inbound after the call is established on R2?
Thanks in advance.
01-01-2009 02:37 PM
what CCM version, please post ur configuration
01-01-2009 02:58 PM
Nop
04-10-2009 03:17 PM
Hi,
I have a similar problem. ANI exists, but it is not really important cause I am doing vm-integration so DTMF digits should be passed on to activate call forwarding on Unity, so the actual ANI does not make any difference.
I see the call is made from SRST router and it gets to Unity, but it always plays out the Openning Greeting handler and I don't think that DTMF digits are actually being passed. I also used Port Monitor tools in Unity Depot and it does not show any DTMFs arriving on that call....
Had anyone seen this before?
Thanks,
David
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide