Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Attention: The Community will be in read-only mode on 12/14/2017 from 12:00 am pacific to 11:30 am.

During this time you will only be able to see content. Other interactions such as posting, replying to questions, or marking content as helpful will be disabled for few hours.

We apologize for the inconvenience while we perform important updates to the Community.

New Member

RAID with MCS7825-I4

Hi all,

I'm just trying to figure how it works raid / mirroring on MCS7825-I4 with callmanager 7.1(3). Here the step I followed:

1) installed and configured ccm with both drive inserted in the slot ( primary on the left and secondary on the right )

2) switched down the server

3) removed the secondary phisical drive and inserted a new one

4) Waited until both drive was SYNC ( with the CLI command show hardware )

At this point i don't know how can I use this new mirrored drive, or better:

a) Can I insert it in a brand new server so I can have a ccm clone ( just in case of fault of my old server / HDDs ) ?

b) Because I got this mirror copy inserting the HDD into the right slot of the old server, in the new server I've to insert in the same slot ? I ask this because the pdf guide of the raid controller say that if I've just one HDD, I've to insert in the left slot.

Many thanks in advance

Luigi

207
Views
0
Helpful
0
Replies
CreatePlease to create content