Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Re: Cisco 7962 with Shared Lines

Hi

I am having a challenge with the configuration of shared lines  on Cisco 7962 phones. Environment is Cisco unified Communication Manager 7.1.3

Scenario

Two Cisco 7962 phones with have the three DN configured,

Phone 1 Line 1= 1000, Line 2= 1001, Line3=1003 assigned to Manager

Phone 2  Line 1 = 1001, Line 2= 1000, Line 3 = 1004 assigned to Secretary

When an incoming calls comes to DN 1001 which the primary DN for the secretary, it is configured to flash on Phone 1 and ring on the primary.

The challenge however is when an incoming call rings at  1001 , if phone 1 lifts the receiver  to make a call automatically the incoming call is answered.

Is there a way to prevent this from happening?

MLaing

1 ACCEPTED SOLUTION

Accepted Solutions
Bronze

Re: Cisco 7962 with Shared Lines

Try adjusting the Auo Line Select option to disable under the phone configuration setup.

mark

3 REPLIES
Bronze

Re: Cisco 7962 with Shared Lines

Try adjusting the Auo Line Select option to disable under the phone configuration setup.

mark

New Member

Re: Cisco 7962 with Shared Lines

Were you able to fix the line appearance issue with your Cisco 7962G

?

New Member

Re: Cisco 7962 with Shared Lines

Yes this resolved my issue

329
Views
0
Helpful
3
Replies