Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Re: Cisco Call Manager express 7.0

I have installed and configured CME 7.0 and Unity Express and I was able to access and configure DN and Phones using the webinterface from Unity Express. However now when I access the Unity Express page and try to configure phone or extension I can't. The CME page launches but there is a X beside IP Telephony Service Engine and can't make these changes. Note dnedit and webedit are enabled. Can you assist with this?

199
Views
0
Helpful
0
Replies