We are able to add the alternate destination via the CCMUser but in some case the line assignment is not done automatically and we have to do it via CCMadmin. See my tests:
If I create a new Alternate Number for “Reach Me Anywhere” and assign this number to a Remote Destination Profile then the Line Association is checked by default.
But when I create a new Alternate Number for “Reach Me Anywhere” and assign this number to a Dual Mode Phone device (Cisco Jabber for iPhone - TCT) then the Line Association is not checked.
This is because the user interface creates a Remote Destination for a Remote Destination Profile and not a Mobile Identity for a Dual Mode Phone device (TCT).
If the administrator creates a Mobile Identity for a Dual Mode Phone, then you don’t need a Line Association.
So to avoid the problem with the Line Association not selected, they should create a Remote Destination Profile and associate the Remote Destination with this profile and not with the Dual Mode Phone Device (TCT).
But the question is, is this behavior working as designed or it should be automatically assigned to the line ?
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...