I'm trying to use real time monitoring tool, but its asking for the host IP address and password. The host IP, is it the IP address of my CCM? and the password, is it the one i use to login on my CCM? thanks.
Hi James, here is some information taken from the RTMT admin guide for launching and logging into the application.
The information you are refering is detailed from Step2, this should clarify your questions:-
Before You Begin
Cisco AMC Service automatically starts up after installation. Cisco Unified Communications Manager automatically assigns the first node as the Primary Collector. For RTMT to continue to retrieve information when the primary collector fails, you must configure a subsequent node as the failover collector in Cisco Unified Communications Manager Administration.
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: email@example.com Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...