Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Users might experience few discrepancies in Search results. We are working on this on our side. We apologize for the inconvenience it may have caused.
New Member

rebooting all 7941s

Hi experts,

Is there a way to reboot thru Call Manager or other to reboot only those 7941 phones? We just upgraded the firmware.

Tnx

1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Red

Re: rebooting all 7941s

Hi Robert,

Sure, via ccmadmin if you go to Device>Phone>Search by Device Type>7941 and all the 7941's will be available (check 50 per page). Then Select-All checkbox and reset. You just go page by page and reset all 50.

Hope this helps!

Rob

2 REPLIES
Hall of Fame Super Red

Re: rebooting all 7941s

Hi Robert,

Sure, via ccmadmin if you go to Device>Phone>Search by Device Type>7941 and all the 7941's will be available (check 50 per page). Then Select-All checkbox and reset. You just go page by page and reset all 50.

Hope this helps!

Rob

New Member

Re: rebooting all 7941s

In addition to the solution Rob gave you, you might want to use BAT if you want to reboot an hugh amount of Phones (Update Phones -> search by Device Type -> select "reset phones" -> press update).

Remember though that the Communications Manager (CallManager) throttles the number of TFTP requests to control/reduce the load.

Regards,

Eric

110
Views
0
Helpful
2
Replies
CreatePlease to create content