We have a mix of avaya ip phones and cisco in our environment. I was wondering what's the best settings to be configured on the interface to which the avaya phone is connected.Also, how can i also ensure avaya phones connected to this port get the necessary QoS settings?
Here's what i have
switchport mode access
switchport access vlan x
switchport voice vlan x(this should set up a trunk port with the ipphone as well right?)
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.