Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Recover Blank Cisco IP Phone

I have a CP-7906G IP Phone.

I have hard resetted the IP Phone with this boot up sequence command

hold # 123456789*0#

I have also done a another settings which I think it's a factory default settings.

hold # 3491672850*#

After doing the second boot up sequence, my IP Phone screen went blank and I can't seem to do anything at all.

Please help me what I should do from here to load a working SCCP or SIP firmware.

Thanks.

1 REPLY

Re: Recover Blank Cisco IP Phone

Hello,

The second sequence makes the phone take longer to start working again. It's normal to see the phone like dead. Make sure the phone have access to DHCP and TFTP. You can use wireshark to see what's going on with your phone and troubleshoot if necessary.

Let us know.

Kind regards,

- Adrian.

203
Views
0
Helpful
1
Replies
CreatePlease login to create content