Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Redial problem

Hi,

When a redial button is selected, it adds another 0 to the number dialed before.  Can you advice what the problem could be or where in CUCM that requires investigation?

TIA.

PF

3 REPLIES
Cisco Employee

Re: Redial problem

It depends on the number, there are some parameter for PSTN calls, you can also have translation rules or called party transformations.

There are a number of places but you don't mention what kind of call or CUCM version so then I'd recommend you to review all of the above.


HTH

java

If this helps, please rate

www.cisco.com/go/pdihelpdesk

HTH

java

if this helps, please rate

www.cisco.com/go/pdi
New Member

Re: Redial problem

If you think the telco is appending it, then look at the debug isdq q931 debugs. You might use the pri debugger tool

http://pippinsoftware.com/photo_gallery/T1PRIDEBUGGER_BLACK.jpg

New Member

Re: Redial problem

Hi javalenc and yxsjusb,

Just want to say thanks very much for the help.  It was the translation rule that is set incorrectly.

Thanks.

PF

220
Views
1
Helpful
3
Replies