Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Redirect to specific E1

Hi !!

i have a gateway 2821 with 4 E1.. (3 with pbx and 1 with my local telecom)

This one with the local telecom is for IPCC entering calls... I'd like the external calls from Agents use this same E1 ..

How can I send the calls to an especific E1 ??

Thanks.

Andrei.

2 REPLIES
Bronze

Re: Redirect to specific E1

Create a Route Group and place this port into that route group.

Then Add the route group to a new route list.

Then assign whatever route patterns you need to this route list

regards

mark

New Member

Re: Redirect to specific E1

Great ! I found it..

One problem... the 3 E1 (QSIG) are there... but the E1 with R2 is not there ... is there any way to put this E1 in the Route Group ?

I entered in the router to see it's config..

---

controller E1 1/0/1

framing NO-CRC4

clock source internal

ds0-group 1 timeslots 1-15,17-31 type r2-digital r2-compelled ani

cas-custom 1

country brazil

metering

category 2

answer-signal group-b 1

dnis-digits min 1 max 4

---

155
Views
0
Helpful
2
Replies