Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

redirecting outgoing call to specifc voice-port on CME 4.1

Hello

Is it possible to force outgoing calls to use specific voice-port ?

For example: I have two pools: 1.. and

2.. and 3 voice-ports 0/0/0, 0/0/1 and 0/1/0.

A would like pool 1.. to use always first free voise-port (it is default) but pool 2.. first try to use voice-port 0/1/0 and then if it will be busy use remaining voice-ports.

thanks in advance

1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Gold

Re: redirecting outgoing call to specifc voice-port on CME 4.1

This can be done with trunk command and trunk groups. It's a bit complicated, so bear with me:

voice-port 0/0/0

trunk-group first

voice-port 0/0/1

trunk-group first

voice-port 0/1/0

trunk-group second

dial-peer voice 10 pots

desc this for use by pool 1

destination-pattern 9...T

trunkgroup first 1

trunkgroup second 3

dial-peer voice 80 pots

desc this for use by pool 2

destination-pattern 89...T

trunkgroup second 1

trunkgroup first 3

ephone-dn-template 1

trunk 8

ephone-dn xx dual-line

! this is a pool2 ephone for external calls

ephone-dn-template 1

Note now, the trunk command always prepend the digit 8 so that DP 80 is selected. But since the digits 8 is prepended for internal calls too, either you configure a trasnaltion profile to remove it, or configure an additional ephone-dn to make external calls, and place that on a separate button form dns in pool 2.

Hope this helps, please rate post if it does!

1 REPLY
Hall of Fame Super Gold

Re: redirecting outgoing call to specifc voice-port on CME 4.1

This can be done with trunk command and trunk groups. It's a bit complicated, so bear with me:

voice-port 0/0/0

trunk-group first

voice-port 0/0/1

trunk-group first

voice-port 0/1/0

trunk-group second

dial-peer voice 10 pots

desc this for use by pool 1

destination-pattern 9...T

trunkgroup first 1

trunkgroup second 3

dial-peer voice 80 pots

desc this for use by pool 2

destination-pattern 89...T

trunkgroup second 1

trunkgroup first 3

ephone-dn-template 1

trunk 8

ephone-dn xx dual-line

! this is a pool2 ephone for external calls

ephone-dn-template 1

Note now, the trunk command always prepend the digit 8 so that DP 80 is selected. But since the digits 8 is prepended for internal calls too, either you configure a trasnaltion profile to remove it, or configure an additional ephone-dn to make external calls, and place that on a separate button form dns in pool 2.

Hope this helps, please rate post if it does!

106
Views
0
Helpful
1
Replies
CreatePlease login to create content