Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Reg: Preferences

Hi Guys,

If I have two voip dial peers (with call managers address given in each one i.e. 10.1.1.1 and 10.1.1.2) configured, one with no preference command (call manager address 10.1.1.1) at all and one with preference 1 (call manager address 10.1.1.2). Which will be the primary call manager for the router. Is there any command to see which is the primary call manager on the H323 gateway.

Tks

1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Silver

Re: Reg: Preferences

The default preference is 0, so the one without preference explicitely configured will be the prefered one, in your example dial-peer pointing to 10.1.1.2.

A good command to test this is "sh dialplan number xxxx"

HTH, please rate all useful posts!

Chris

2 REPLIES
Hall of Fame Super Silver

Re: Reg: Preferences

The default preference is 0, so the one without preference explicitely configured will be the prefered one, in your example dial-peer pointing to 10.1.1.2.

A good command to test this is "sh dialplan number xxxx"

HTH, please rate all useful posts!

Chris

New Member

Re: Reg: Preferences

I beleive it should be 10.1.1.1 as no preference is configured for that.

Good day

96
Views
0
Helpful
2
Replies