just follow the instructions on the doc on how to transform the data.
a google on unity epoch time will give you the formula
If u mean that you want the exported data to have it all in a readable format thats not possible, that is the way the CDR dump is and there is no way to change that thru any parameters, thats why we provide the doc
The system stores IP addresses as unsigned integers. The database displays them as signed integers. To convert the signed decimal value to an IP address, first convert the value to a hex number, taking into consideration that it is really an unsigned number. The 32-bit hex value represents four bytes in reverse order (Intel standard). To determine the IP address, reverse the order of the bytes and convert each byte to a decimal number. The resulting four bytes represent the four-byte fields of the IP address in dotted notation.
Note The database displays a negative number when the low byte of the IP address has the most significant bit set.
For example, the IP address 192.168.18.188 displays as -1139627840. To convert this IP address, perform the following procedure:
Step 1 Convert the database display (-1139627840) to a hex value.
The hex value equals 0xBC12A8C0.
Step 2 Reverse the hex bytes, as shown below:
CO A8 12 BC
Step 3 Convert the bytes from hex to decimal, as shown below:
192 168 18 188
Step 4 The IP address displays in the following format:
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.