Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

Cisco Employee

register an mcu with call manager over ipv6

Hi all,

We are trying to register a MCU conference bridge with a call manager 10.5 with ipv6 only. We have been unable to have this working, apparently call manager does not resolve the name but can ping properly to the MCU ipv6 address. DNS settings are fine and while the MCU can resolve all names call manager can't.

 

Is there any missing configuration there to have the MCU registered and call manager resolving names under ipv6 only config??

Regards,

 

Juan 

  • IP Telephony
16
Views
0
Helpful
0
Replies
This widget could not be displayed.