03-29-2007 12:38 PM - edited 03-14-2019 08:45 PM
03-29-2007 12:52 PM
Sure. Under ephone, configure g729 and mtp.
03-29-2007 12:52 PM
Sure. Under ephone, configure g729 and mtp.
03-29-2007 05:47 PM
Thanks
04-01-2007 08:12 AM
can u pls send me MTP part.
thx
04-01-2007 08:18 AM
Sandeep,
Here are some good links.
04-01-2007 09:51 PM
jose,
cisco design says not to configure any remote location phone using cme.
But yes techinically you can configure it.No CME phones supports locally g729 codec. so u cannot use it.This is the only reason why i feel cisco doesnt recommends to use phones across.
-
vishwesh
04-01-2007 11:54 PM
hi Vishwesh,
can u pls provide some link where cisco is not recommending registeration over the WAN.
we are seriously looking for this.
regards,
04-02-2007 03:11 AM
K.Vishwesh is incorrect.
You can perfectly deploy remote phones with CCME and Cisco has never recommended against.
From CCME 4.1 Datasheet at:
http://cisco.com/en/US/products/sw/voicesw/ps4625/products_data_sheet0900aecd805e1a1f.html
...
Remote tele-worker IP phone support
...
Link to configuration guide for remote phones:
Also stating that the phones do not support G.729 is oncorrect. To the contrary, all telephones do support it.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: