Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Registering an IP Phone thru a WAN using CME

Can I do this?

If yes, Can I configure it to use G729?

Regards, Jose

1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Gold

Re: Registering an IP Phone thru a WAN using CME

Sure. Under ephone, configure g729 and mtp.

7 REPLIES
Hall of Fame Super Gold

Re: Registering an IP Phone thru a WAN using CME

Sure. Under ephone, configure g729 and mtp.

New Member

Re: Registering an IP Phone thru a WAN using CME

Thanks

New Member

Re: Registering an IP Phone thru a WAN using CME

can u pls send me MTP part.

thx

Re: Registering an IP Phone thru a WAN using CME

New Member

Re: Registering an IP Phone thru a WAN using CME

jose,

cisco design says not to configure any remote location phone using cme.

But yes techinically you can configure it.No CME phones supports locally g729 codec. so u cannot use it.This is the only reason why i feel cisco doesnt recommends to use phones across.

-

vishwesh

New Member

Re: Registering an IP Phone thru a WAN using CME

hi Vishwesh,

can u pls provide some link where cisco is not recommending registeration over the WAN.

we are seriously looking for this.

regards,

Hall of Fame Super Gold

Re: Registering an IP Phone thru a WAN using CME

K.Vishwesh is incorrect.

You can perfectly deploy remote phones with CCME and Cisco has never recommended against.

From CCME 4.1 Datasheet at:

http://cisco.com/en/US/products/sw/voicesw/ps4625/products_data_sheet0900aecd805e1a1f.html

...

Remote tele-worker IP phone support

...

Link to configuration guide for remote phones:

http://cisco.com/en/US/products/sw/voicesw/ps4625/products_configuration_guide_chapter09186a00807e13a7.html#wp1061320

Also stating that the phones do not support G.729 is oncorrect. To the contrary, all telephones do support it.

190
Views
1
Helpful
7
Replies
CreatePlease to create content