Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Registering NM-HDA-4FXS with CCM over MGCP

Hello all,

Brought up a remote office this morning with a 2821 router/voice gateway.  The PRI is up and running fine and is registered with remote Callmanager over MGCP.  However, I am trying now to register the NM-HDA-4FXS in the same router, but cannot seem to get it working.  I have it defined in the gateway config in my call manager, but it is not registering.  I suspect that I need to "tell" it it needs to register with the callmanager like I have to do with the T1 controller and resulting serial interface, but I don't see what commands are available to do that for the NM-HDA-4FXS or resulting voice ports.  Does anyone know?

Router is a Cisco 2821, IOS version is 12.4(11)T2.  CCM version is 6.1.3000-1.

Thanks,

Chris

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: Registering NM-HDA-4FXS with CCM over MGCP

Chris,

You need to have POTS dial-peers for the analog ports.  This should suffice:

dial-peer voice 100 pots

  port 1/0/1

  service mgcpapp

You can verify with:

sh mgcp end

If you have MGCP CCM config server enabled, if that's working properly, it should have added that for you, with a dial-peer ID of 999something.

ccm config

ccm config server

'sh ccm' will let you know if the config downloading is failing.

-Steve Holl

2 REPLIES
Cisco Employee

Re: Registering NM-HDA-4FXS with CCM over MGCP

Chris,

You need to have POTS dial-peers for the analog ports.  This should suffice:

dial-peer voice 100 pots

  port 1/0/1

  service mgcpapp

You can verify with:

sh mgcp end

If you have MGCP CCM config server enabled, if that's working properly, it should have added that for you, with a dial-peer ID of 999something.

ccm config

ccm config server

'sh ccm' will let you know if the config downloading is failing.

-Steve Holl

New Member

Re: Registering NM-HDA-4FXS with CCM over MGCP

Steven,

Thanks!  The dial-peer is exactly what I needed.  I had the card shutdown when I did the inital MGCP setup and config download, so I suspect that that is why the dial peers didn't get automatically created like they do on my VG224s.

It's working great now.

Thanks,

Chris

166
Views
0
Helpful
2
Replies
CreatePlease login to create content