Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Registration Rejected -Valcom SIP Paging Server

                  Hello everyone,

Running UCM 8.6 and integrating a Valcom SIP paging unit.  I am getting a Registration Rejected" message in UCM for the SIP phone that was created.  Any ideas on where to look to figure out why the registration is being rejected?  Not doing auto-reg.

Thanks in advance.  All replies rated.

  • IP Telephony
1 REPLY
New Member

Registration Rejected -Valcom SIP Paging Server


(vendor reply)

Typical reasons for registration failure could be a mismatch in the user ID or password used in the Valcom SIP paging unit with the User credentials created on the UCM.  The following link goes to a configuration document on the Valcom web site for using a Valcom SIP device on UCM:

http://www.valcom.com/techsupport/config-docs/Cisco%20UCM%207.1%20SIP%20Configuration%20Guide.pdf

413
Views
4
Helpful
1
Replies
This widget could not be displayed.