Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

relay fac from PRI to BRI

I'm designing a new CME implementation with ether UC560 or ISR2921. we have a PRI line where we recieve voice and fax, and an internal fax server with BRI card.

Is it possible to configure relay for specific call comming on PRI card (based on called number) to a BRI interface connect to the fax server?

Any configuration exemple is welcome!

Sent from Cisco Technical Support iPhone App

1 REPLY
Green

relay fac from PRI to BRI

Hi,

If the FAX calls are incoming on PRI straight to BRI then there is NO voip therefore FAX relay or passthrough are not involved

If the calls to fax are all to a dedicated called number then you should be able to capture these with dial peers.

Something like this:-

!

dial-peer voice 100 pots

description *** FOR INCOMING FAX CALL MATCHING 4321 ***

incoming called-number 4321

direct-inward-dial

port 0/0/0:15

!

!

dial-peer voice 201 pots

description *** FOR INCOMING FAX CALL MATCHING 4321 TO BRI ***

destination-pattern 4321

port 1/0/0

pref 1

!

!

dial-peer voice 202 pots

description *** FOR INCOMING FAX CALL MATCHING 4321 TO BRI ***

destination-pattern 4321

port 1/0/1

pref 2

!

Regards,
Alex.
Please rate useful posts.

Regards, Alex. Please rate useful posts.
149
Views
0
Helpful
1
Replies
CreatePlease login to create content