Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Remote Destination as OCS-Client

Hi,

I have probem with CUCM 7.1.3a and mobility/remote destination.

scenario:

Phone A  (dn = 1000)

Phone B (dn = 1001)  with  two remote destinations  (mobile/gsm and OCS Client)

I configured 2 remote destinations for  remote destination profile B

First remote destination points to a mobile/gsm phone => this works !

Second remote destination e.g.  "9010"  points to:   route pattern  (90xx) => route list  => sip trunk to MS  OCS

but   the remote OCS Client doesnt ring !

If  I call from phone A  (dn = 1000)     directly  to the corresponding OCS dn  (9010)  =>  works !

I checked  rerouting css  etc. ... its ok ,  OCS-dn (Route pattern)   and  phone-dn  are all in the same enddevice partition

my question:

Is mobility/remote destination compatible with SIP-Trunk to  e.g. OCS ?

or does mobility/remote destinatin  only support "classical"   H.323/MGCP  TDM-PSTN outbreak ?

kind regards

Michael

1 REPLY

Re: Remote Destination as OCS-Client

I was about to post the same question. I have exactly the same problem. SNR to a cell phone works, but to MOC number doesn't work. If I call MOC number directly, it works, but not through remote destination profile. You probably followed the same PDF document I did that explains how to set this up. I verified everything and still no luck. I'm running 7.1(5).

if you find anything, please let me know.

430
Views
0
Helpful
1
Replies