I would like to clean up my CUOM install and remove the cluster that it initially discovered before I rememberd to change the Enterprise Parameter in CUCM from "StandAloneCluster". Now I have two clusters one with my newly named cluster and one with "StandAloneCluster". Can I remove the "StandAloneCluster"?
Since CUOM does not add devices as whole clusters but adds them individually my best bet would be to manually delete the servers that make up the "StandAloneCluster" from CUOM (Administration>Device Configuration>Modify/Delete Devices). Also note that it may take a little while for the changes to be reflected within CUOM. Thanks.
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: email@example.com Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...